Black Box CCTVTEST, CCTV Tester manual Operation Power and Battery, Main Menu Introduction

CCTV Tester

3. Operation

3.1 Power and Battery

POWER: The power ON/OFF switch is located on the side of the tester.

BATTERY SAVER: The tester has a battery-saving sleep mode. Turn the slide switch ON again if the tester is asleep.

RECHARGEABLE BATTERY: The tester has a non-removable battery for a larger capacity. Do not open the rear panel and attempt to repair it.

CHARGE TIME: The battery requires five hours for a full charge.

CHARGE LED: While charging, the “Charge” LED will be ON.

OPERATING TIME: Approximately 10 hours.

WHEN TO RECHARGE: Recharge when the battery indicator in the System Setup menu shows 25% or less.

USE WHILE CHARGING: The tester can be used during charging.

3.2 Main Menu Introduction

Turn on the device. The Main Menu appears: #1 is the setup mode. #2 thru #6 selects five test modes. Use the keypad’s numbered buttons to select the menu item. The last item is the software version and serial number.

MAIN MENU

1 SYSTEM SETUP

2 VIDEO AND PTZ TEST

3 UTP CABLE TEST

4 VIDEO GENERATOR

5 RS485 DATA TEST

6MULTIMETER VER:V1.11 S/N:08110910

>Set up PTZ and check battery

>Test video and control PTZ

>Test UTP cables

>Test video monitors

>Analyze RS-485 protocol

>Measure voltage/resistance

>Software version and S/N

Figure 3-1. Main Menu.

Page 14 724-746-5500 blackbox.com