Black Box FX802A, FX810AE, FX800A, FX801A manual Transmitting a Message Code to All System Pagers

CAMPUS PAGER

NOTE

You cannot reset either of these codes after you press the TRANSMIT button.

4.Press the TRANSMIT button. The TRANSMIT display lights during transmission, and the pager’s display flashes the message code number seven times. The three digits will remain lit until you perform one of the following actions:

•Turn the Campus Pager OFF

•Press A/C or CANCEL

•Transmit a message to a pager

If desired, press TRANSMIT again to re-send the current message code to the pager.

5.Press A/C or CANCEL, then repeat Steps 3 and 4 if you want to transmit another message code to another pager.

5.5Transmitting a Message Code to All System Pagers

1.Turn the Campus Pager power ON.

2.Press A/C or CANCEL if the display shows unwanted pager or message codes.

3.Press ALL, then the one digit message codes that you would like to send. If you enter the wrong message code, press A/C or CANCEL, then re- enter the correct code.

NOTE

You cannot reset the message code after you press the TRANSMIT button.

4.Press the TRANSMIT button. The TRANSMIT display lights during transmission, and the pager’s display flashes the message code number. See Section 5.6. If desired, press TRANSMIT again to re-send the current message code.

5.Press A/C or CANCEL, then repeat Steps 3 and 4 if you want to transmit another message code.

24