Chapter 3: Hardware Configuration
3. Hardware Configuration
3.1 Serial Server Indicators, Switches, and Connectors
3.1.1 Indicators
•One
•One green Ready LED (flashing = system ready)
•One red Power LED
•One red RX LED and one green TX LED for each serial port
3.1.2 Switches
Reset
A recessed reset switch that enables the unit to be reset. Insert a small plastic tool, press lightly and hold for three seconds. The Link and Ready lights will go out and then come back on.
Run/Console Switch
A recessed single DIP (dual inline package) switch that allows the Serial Server to be switched between Run Mode and Console Mode. When switched to the Console position, the Serial Server enters Console Mode. This allows you to configure the Serial Server from a PC running a terminal program, such as HyperTerminal®, without connecting the server to the network. To communicate with the connected serial device, the switch must be returned to the “Run” position.
DB9/Terminal Switch
Allows connection to the serial port
3.1.3 Connectors
Ethernet Connector
One standard
Serial Port(s)
•
(DIP switch selectable)
•
•
NOTE: Refer to Appendixes A, B, and C for connection pinouts.
Page 19 |