ServSensor EXP 8
3. Installation
3.1 Connecting to the Base Unit
To connect the ServSensor EXP 8 to the ServSensor V4E, follow the steps listed below.
1. Connect the cable to your chosen port on the ServSensor. See Figure
Figure 3-1. E1 port.
2. Connect the other end to the “E-in” port on the expansion module. See Figure 3-2.
Figure 3-2. E-in port.
NOTE: Make sure that the
The expansion modules can be mounted in either a standard configuration or a daisychained configuration, as shown in Figures 3-3 and 3-4.
Figure 3-3. Standard configuration.
In the example shown in Figure 3-3, two expansion modules are connected from two separate expansion ports on the ServSensor. In the example shown in Figure 3-4, the same two modules are connected to one expansion port in a daisychain configuration.
Page 10 |
