Black Box EXP 8, ServSensor manual Installation

Chapter 3: Installation

3.When the unit is connected, the LEDs will enter the boot-up sequence indicating that the expansion module (EME1X8) is communicating with your ServSensor V4E (EME134A).

4.Plug a sensor into one of the RJ-45 “intelligent sensor ports” on the rear panel of the unit. In this example, we will use Port 1.

Figure 3-13. Plug sensor into Port 1.

5.After the unit is connected, access your Web interface, click on the desired IP address and log in, and navigate to the summary page. Two boards will be displayed within the sensor information window as shown in Figure 3-14.

Figure 3-14. Sensor information window.

6. Click on the lower of the two boards and the sensors page will appear.

NOTE: You can also access this page by clicking on the “Sensors” tab at the top of the summary page.

724-746-5500 blackbox.com Page 15