Black Box LWN602WA manual Ethernet Protector, Connecting the PoE injector inline

SmartPath Enterprise Wireless Access Point, Outdoor Installation Guide

press the Reset button on the chassis and hold it down for at least 10 seconds.

9. Ethernet Protector

In most cases, you can connect an Ethernet cable directly from the LWN602WA to a PoE-enabled switch or PoE injector (LPS001A-J) inside the building. In some cases, you might need to install an outdoor waterproof PoE injector, available separately (contact Black Box Technical Support at 724-746-5500 or info@blackbox.com for details).

The LWN602WA and outdoor PoE injectors have built-in surge protection to guard against lightning strikes. However, the network where the Ethernet cable enters the building requires protection as well. To prevent the indoor network from power surges caused by lightning, place an Ethernet protector (indoosr: AL-CAT6JTW; outdoors: HGLN-CAT6JT) inline between the LWN602WA and the rest of the network.

Figure 16. Adding lightning arrestors.

1.Attach the Ethernet protection device to the building at the entry point of the shielded Ethernet cable from the LWN602WA.

2.Make the following connections:

•Ground the device by running a wire from the grounding stud to a grounded object, such as a water pipe, gas pipe, or grounding rod.

•Connect the shielded Ethernet cable from the LWN602WA to the port labeled "Line Side," and connect another Ethernet cable from the port labeled "Equipment Side" to the network.

Figure 17. Connecting the PoE injector inline.

Page 16 724-746-5500 blackbox.com