Chapter 4: Configuration and Setup

4.2Routing the Cable (UCCDS20T, UCCDS20H, UCCDS30T, UCCDS30H, UCCDS40T, UCCDS40H)

1.At the back of the cart, loosen the two screws on the cable manager, pull up on the top section of the cable manager, and place the device side of the charging cable into one of the slots. (See Figure 4-2.)

Loosen screws on cable manager

Cable manager

and pull up

Route cable to the

front of the cart

Power

Strip

Wrap excess cable

Charger

around cable wrap

 

Figure 4-2. Small shelf routing instructions.

2.Replace the top section of the cable manager and tighten the screws.

3.Route the device side of the charging cable to the front of the cart and repeat step 1 for the front cable manager.

4.Wrap any excess cable around the cable wrap on the back of the shelf.

5.Plug the charger power plug into the power strip located below the shelf.

UCCDM20-T

724-746-5500 blackbox.com

Page 15

Page 15
Image 15
Black Box UCCDL18T, UCCDS40H, UCCDS30T, UCCDS30H, UCCDS40T, UCCDS20T, UCCDM36H, UCCDM36T, UCCDS20H, UCCDM27T Around cable wrap