Placing the device in operation

Placing the device in operation

Attaching/detaching the control panel

The car sound system is equipped with a detach- able control panel (release panel) to protect your equipment against theft. In the delivery state, the control panel is in the supplied case. To start op- erating the radio after installation, you must first attach the control panel (see the section "Attach- ing the control panel" in this chapter).

Always take the control panel with you when leav- ing the vehicle. The car sound system is worthless to a thief without this control panel.

Caution

Damage to the control panel

Never drop the control panel.

Transport the control panel so that it is protected against impacts and the contacts cannot become dirty.

Do not expose the control panel to direct sunlight or another heat source.

Avoid direct skin contact with the control panel’s electrical contacts.

Attaching the control panel

￿Push the control panel into the bracket at the right edge of the device.

￿Push the control panel carefully into the left bracket until it clicks into place.

Removing the control panel

￿Press the button 1to unlock the control panel.

The left side of the control panel detaches from the device and is secured by a latch against falling out.

￿Grasp the control panel at the left side and pull it beyond the resistance of the latch and straight out of the bracket.

Note:

The car sound system automatically switches off as soon as the control panel is removed.

Setting the tuner region

This car sound system is designed for operation in

 

different regions with different frequency ranges

 

and station technologies. It is factory set to the

 

tuner region "EUROPE". Other available tuner

 

regions include "USA", "THAI" (Thailand) and

ENGLISH

have to set a suitable tuner region:

"S AMERICA" (South America). If you operate the

 

car sound system outside of Europe, you may first

 

￿Switch off the car sound system if it is not already turned off.

￿Press and hold the buttons MENU•OK ? and 4 <at the same time and press the On/ Off button 3.

The car sound system switches on. The cur- rently set tuner region appears on the dis- play.

￿ Press the button @ / 2 repeatedly until the desired tuner region is displayed.

￿Press the MENU•OK button ?.

Switching on/off

Switching on/off with the On/Off button

￿For switch-on, press the On/Off button 3. The car sound system switches on.

￿To switch off the device, press and hold down the On/Off button 3 for longer than 2 sec- onds.

The car sound system switches off.

Note:

If you switch on the car sound system while the vehicle ignition is switched off, it auto- matically switches off after 1 hour to preserve the vehicle battery.

Switching on/off via vehicle ignition

The car sound system will switch off/on simulta- neously with the ignition if the device is correctly connected to the vehicle’s ignition as shown in the installation instructions and you did not switch the device off by pressing the On/Off button 3.

31

Page 6
Image 6
Blaupunkt 400 BT installation instructions Placing the device in operation, Setting the tuner region, Switching on/off