Blaupunkt RCM 104 Quick instructions, Switching on, Switching off, Fmt, Extra function

Quick instructions

1Switching on:

Hold down the ON button (the KeyCard has to be inserted), the set plays with the pre-adjusted volume.

Switching off:

Press ON for approximately 1 second. If the set was turned on by pressing ON, the KeyCard can be used for swit- ching the system on and off. Please read the information of chapter “Key- Card”.

The set may also be turned off via the vehicle’s ignition (provided that it was connected correspondingly). After the ignition was switched off, a double beep tone reminds you that you should remove the KeyCard before leaving your vehicle.

To operate the set when the ignition is switched off (KeyCard is inserted), pro- ceed as follows:

Press “ON” after the double beep tone. The set will be turned on.

To avoid that the battery goes flat, the system will be turned off automatically after a playback time of one hour.

2To change the volume: Press VOL+/VOL-.

Each time the set is switched on, it will play with the pre-adjusted volume (VOL FIX). You may also change the VOL FIX setting (see chapter “DSC pro- gramming“).

3FMT

Press this button to switch between the memory banks I, II, and T (Travelstore). As soon as this button is pressed, the system will automatically switch to FM.

Extra function:

Store the six most powerful stations automatically with Travelstore: Press FMT until seek tuning starts in the display.

4M•L

To change between medium wave (MW) and long wave (LW) frequencies.

5-dB- for instantly changing the volume Press the -dBbutton to instantly mute the audio source. The display will then show MUTE. Return to normal volume by pressing either the -dBor the VOL+ button.

When pressing VOL-, the normal play- back volume is identical to the -dB(mu- ted) volume.

To program the mute volume, proceed as follows:

•Adjust the desired volume.

•Press -dBfor approximately 2 se- conds (beep tone is released).

This volume will then be stored as the mute volume.

Extra function:

Press this button to store the values set in the DSC menu.

26