Blaupunkt RCM 104 PTY button, Tim/Ta, 3, 4, 5, 6 preset buttons, ? BC Dolby NR

the corresponding slot above the flashing KeyCard tongue.

Read also the information given in the “KeyCard” chapter.

9AF button (alternative frequency) du- ring RDS operation

When “AF” lights up in the display, the system will automatically seek a fre- quency offering better reception of the same RDS program.

“AF” on/off: Press the AF button briefly. When pressing the AF button for about 2 seconds, the display will show REG- ON or REG-OFF (see also chapter REG - Regional).

:PTY button

Use this button to enter the PTY mode. In this mode, the preset buttons are used to select different program types, e.g. SPORT. The system will then only seek stations offering sport programs.

;TIM/TA

TIM (TraffIc Memo)

To play all the stored traffic announce- ments:

Press TIM briefly.

To activate/deactivate the priority for traffic announcements:

Press TIM for approximately 2 seconds. TA (Traffic Announcement)

If TA lights up in the display, the system will only play traffic stations.

TA on/off: Press the TIM button for approximately 2 seconds

<1, 2, 3, 4, 5, 6 - preset buttons

You can store 6 stations on each FM memory bank (I, II, and “T“) and another 6 stations on MW and LW each.

To store a station: Press button during radio operation and hold down until the radio comes on again.

To recall a station: Select the wave- band. On FM, select the desired memo- ry bank and press the corresponding preset button.

=PS

For briefly playing all receivable stati- ons or the titles during tape or changer operation (option).

To start/stop Scan: Press PS briefly.

The scan time can also be altered (see chapter “DSC programming” - SCANTI- ME).

>RM (Radio Monitor)

Press this button to listen to the radio while fast forwarding or fast rewinding the tape.

During tape operation:

To switch RM on/off: Press RM. When this function is activated, the display shows “RM”.

The radio is played during fast tape run.

?B•C – Dolby NR

This set allows you to play back tapes that have been recorded with Dolby-NR B, Dolby-NR C or without Dolby noise reduction.

Press B•C to adjust to the type of Dolby NR in which the tape was recorded or to disengage Dolby NR. When Dolby is active, the corresponding indicator “B” or “C” will light up.

@Eject button Press.

ACassette loading slot

Insert tape (side A or 1 facing up, the open side showing to the right).

28