Blaupunkt RCM 104 operating instructions Selecting the operating mode, Replacing a KeyCard

KeyCard

The car radio can only be operated using either KeyCard 1 or 2. Their codes are stored in the unit.

Turn on the set and introduce the KeyCard completely. The car radio is now ready for operation. When inserting a wrong KeyCard, the display will show “----”.

After approximately 10 seconds, “CARD ERR” will appear in the display. In this case do not make any further adjustments until you have the corresponding KeyCard availa- ble.

Never try to pull out the KeyCard by force. First, slightly press the card in. This releases the KeyCard; the display shows “LEARNING”. Now you can pull out the card. Should the KeyCard be lost or damaged, then please contact one of our authorised service partners to get a new card.

The service centres are marked () in the car radio service centre list. In case of doubt, please contact the central service centre in your country for more information on the KeyCard service centre closest to you.

Use either KeyCard (1 and 2) to individually store the following functions as desired: bass, treble, balance and fader settings, pre- set stations, loudness, TA (traffic announce- ment volume), SPEECH (tone control for

speech programs), BEEP volume, SCANTI- ME, VOLFIX.

In addition to this, the settings activated be- fore switching the radio off, such as the waveband, station, TA priority, loudness, AF, CPS, Dolby B/C, RM, REG ON/OFF or seek tuning sensitivity will also remain stored.

When you insert your KeyCard, the basic settings you have programmed will automa- tically be activated.

Replacing a KeyCard

Any KeyCard can only be replaced by a new one with the same number (1 or 2). Should you wish to replace KeyCard 2, for example:

•Insert KeyCard 1 and switch the radio on.

•Slightly press the card and it will move into the removal position. “LEARNING” will then appear in the display.

•Remove KeyCard 1 and insert the new KeyCard 2 while the display is still showing LEARNING.

Now you can operate the set with the new KeyCard 2.

You can switch the radio on only after inser- ting either a KeyCard 1 or 2.

Selecting the operating mode

With the SRC (source) button you can select between the following modes:

radio,

tape,

CD changer (option), or

operation of another audio component connected.

To select one of the operating modes, it is of course necessary that the corresponding system is available, i.e. the add-on compo- nent must be adequately connected and the sound carrier (cassette, disc, changer maga- zine) inserted.

To switch over to the next operating mode available,

•press the SRC button.

DEUTSCH

ENGLISH

PORTUGUES ESPAGÑ OL SVENSKA NEDERLAND ITALIANO FRANÇ AIS

31