Cassette operation
This unit is equipped with a
After a new cassette has been insert- ed, the
REMAIN.
Scanning cassette titles with | Selecting titles with |
SCAN | (Super Cassette Program Search) |
It is possible to scan the titles on a cassette. To repeat and skip cassette titles. As soon as you find a title you like, you can
end SCAN. This title will then continue to play.
SCAN is active when “SCA” is highlighted in the display. “SCAN” will also appear in the top line of the display.
Track reverse
To change the track during playback:
•Press REV.
When the tape reaches the end of a side it will automatically switch to the other side (autoreverse). “SIDE A” will appear in the display for track 1 and “SIDE B” for track 2.
Note:
If there is too much tension on the tape while it is playing, it may switch to the opposite track before it has reached the end. Check to see if the tape is wound correctly. It often helps to rewind the cassette completely.
Starting/ending SCAN:
•Press SCA briefly.
To ensure that this function works properly, there must be a pause of at least 3 seconds between titles.
The scan time is set to 10 seconds at the factory and can be altered from 5 to 30 sec- onds. If necessary, refer to the section on “DSC programming - SCANTIME”.
/
Select title
Forwards
Back
It is possible to skip up to 9 titles. To do so,
•press 
/
on the rocker switch as of- ten as required.
The number of titles to be skipped will ap- pear in the display.
Make any corrections by pressing the op- posite key (
/
).
Press REV to stop this function immediately.
To ensure that this function works properly, there must be a pause of at least 3 seconds between titles.
68
