Installation
Oven Assembly
VENTILATION
1.Assemble the back vents.
2.Screw the back vent to the rear of each oven section with the offset (enlarged) end toward the bottom. Holes are provided. For stacked units, the top of the lower back vent fits inside the bottom of the upper vent.
3.Secure the trim to the top right of the upper oven. The flanges on the right side, back and front of the trim collar fit under the crown.
Use three sheet metal screws to attach the left side of the trim to the top of the oven body
4.Remove all tags.
Figure 4
ULTRA ROKITE DECKS
Use only Blodgett Ultra Rokite Decks. Use of decks other than Blodgett will invalidate the warranty.
NOTE: Ultra Rokite shelves are heavy be careful when handling.
1.Slide 1/2 of the Ultra Rokite shelf through the door until it rests on the deflector. Move the shelf to the rear until it drops into the shelf sup- port. Push to the right.
2.Slide the remaining shelf through the door un- til it rests on top of the other half. Move the shelf to the rear until it drops the shelf support. Push all the way to the left.
3.Move both shelves in so the center joint closes.
4.Level with shims provided if necessary.
5.Refer to preheating instructions supplied with shelf.
ELECTRICAL CONNECTION
Before making any electrical connections to this unit check the rating plate to be sure that the oven is being connected to the proper electrical supply. The supply conduit is connected to the right rear of each oven section.
1.Remove the trim cover on the right lower front of the oven to access the supply connecting terminals.
2.Run the supply wires through the conduit to the front of the oven.
3.Connect the supply wires to the circuit breaker on the lower right front corner of the control panel.
NOTE: When using an interconnection kit, refer to detailed instructions supplied with the kit.
6
