Use & Care Manual
ENGLISH
Switching off a cooking zone as described below |
|
disables the Low Power mode. When the zone will be | level: |
selected again it will start to work in the standard power |
|
mode. |
|
| same power level and both extension lights (ref.1a, |
| 1b) turns on. |
heating element. |
|
You may turn off all active elements at the same time by | (ref.6a, 6b) turns on. Set the power level that will be |
| immediately and simultaneously displayed on both |
| displays. |
outer ring of a double zone. This operation is possible
The dual element enabling indication (ref.5a) is on when the element is enabled, is off when the element is disabled.
outer rings of a triple zone:
ring is enabled too.
enabled, the outer ring is enabled too.
intermediate rings are disabled.
These operations are possible until the HOT SURFACE
The intermediate element enabling indication (ref.5a) is on when the double element is enabled, is off when the double element is disabled.
The outer element enabling indication (ref.5b) is on when the triple element is enabled, is off when the triple element is disabled.
Select one of the two single heating areas belonging
element and set the whole cooking area as a single unit.
This operation is possible until the HOT SURFACE led
6b
6a
3
3
Figure. 9
used indifferently to control the bridge area. All actions will have the same effect on the whole cooking area.
active. It’s always necessary to switch the area off: the bridge will be disabled automatically.
Each element has a HOT SURFACE indicator light (ref.3) to show when the cooking area is hot.
This indication turns on when the zone is activated and remains ON until the cooking area has cooled down to
If a hot surface light is ON use caution when working around the cooktop as it is still hot.
Once a heating element has been selected, touch the
or after setting the power level.
A beep sounds and the heater display shows the selected power level and a “P” alternatively.
11
