Blomberg DV 17540 NBL00, DV 17542 installation instructions Destroying packaging material

elbows to not hinder air flow.

CTo prevent water accumulation in the duct, make sure it is not folded on the floor.

CIn Canada only those foil-type flexible ducts, if any, specificially identified for use with the appliance by the manufacturer shallbe used. In the United States, only those foil-type flexible ducts, if any, specifically identified for use with the appliance by the manufacturer and that comply with the Outline for Clothes Dryer Transition Duct, Subject 2158A, shall be used.

AThe appliance should not be vented into a chimney, a wall, a ceiling, an attic, a crawl space or a concealed space of a building.

ADo not operate the appliance at the same time with heaters such as a coal or gas stove. Airflow may cause the chimney to flare up.

C Care must be taken not to pinch or bend the ducts.

C The end of the hose should not be bent, it should not be stepped on and it must not be folded between the drain and the machine.

CThe total lenght of flexible metal duct shall not exceed 7.8 foot (2.4 m).

CThe duct shall not be assembled with screws or other fastening means that extend inside the duct to catch lint.

Destroying packaging material

Packaging material can be dangerous to children. Keep the packaging materials out of the reach of children or dispose of them accordingly. Do not dispose of them together with normal domestic waste.

Packaging materials of your appliance are manufactured from recyclable materials.

12 - EN