Blomberg KWD 9440 XA++, KWD 9440 X A+, KWD 9330 X A+ Connection of Water Hose to the Jug

Connection of Water Hose to the Jug

(in some models)

To connect water to the refrigerator from a jug, a pump is needed. Follow the instructions below after connecting one end of the water pipe coming out of the pump to the refrigerator as described on the previous page.

Connection of the Water Pipe to the Cold Water Mains Line

(in some models)

If you want to use your refrigerator by connecting it to the cold water mains line,

you will have to connect a standard 1/2” valve connection fitting to the cold water supply in your house. In case this valve is not present or in case you are not sure, consult a qualified plumber.

1a

1.Finish the connection by pushing the other end of the water pipe into the water pipe inlet of the pump as shown in the figure.

2.Put and fix the pump hose into the jug as shown in the figure.

3.After completing the connection, plug in and run the pump.

To provide an efficient operation of the pump, wait for 2-3 minutes after starting the pump.

C Note: You may refer to the user manual of the pump while making the water connection.

1b

2

17

EN