Reversing The Doors
We recommend that you reverse doors before switching on for the first time.
Tools required: Small and medium size flat and
Spare Parts supplied in the plastic bag: The following parts, which are exclusively for left hand side fitted hinge operation are supplied in a plastic bag with the appliance:
-Upper door top trim hinge covers – there are 2 different parts, one for each side of top trim.
-Upper door middle hinge bushing/ door stopper assembly.
We suggest you keep all the parts supplied in the plastic bag and also parts, which have been removed when reversing doors, in a safe place for possible future,
IMPORTANT: We suggest you ask somebody to help you when moving the appliance around and to hold doors when removing /
Please refer to diagrams supplied. To follow numbers in brackets below, refer to the main diagram.
1.Switch off the appliance at the socket outlet and pull out the mains plug.
2.Remove all food, loose items and fittings from inside the appliance and door shelves.
3.Carefully tilt the appliance on
its back side. (1) (You may need somebody to help you.) Take care not to damage the appliance by laying on some protective material (e.g. its original packaging). Make sure that you tilt the appliance on its back side, otherwise compressor oil may block the pipes and you may damage the appliance.
4.Unscrew and remove the LHS front feet and bolt (2).
5.Unscrew the bolts and remove the bottom hinge while holding the door
(3).
6.Remove the door carefully from the top hinge by sliding down wards (4).
7.Reposition top hinge bushing and
blanking plug on the opposite side and stand the door safely (5). You may find it easier to remove the bushing and the plug with the tip of a small screwdriver. Take care not to mark the door.
8.Remove the two screws from the top front plastic trim (6)
9.Remove the bushing of the four-
star compartment cover hinge(7); Pull out the cover (8) and remove pin on the upper wall (9) Remove the locking mechanism (10)
10.Remove the two screws from the back of the top plate (11) and remove the top plate (12)
11.Remove the top hinge and re- position it on the opposite side (13)
10
EN
