Linksys EtherFast Series
9. Reconnect your PC’s power, then power on your computer. Your com-
puter will automatically recognize the card and assign it a unique IRQ
("interrupt") and I/O address.
The card installation is complete. Next, you must configure your PC’s
operating system to work with the EtherFast Card.
• ForWindows 98 configuration instructions, turn to page 7.
• For Windows 95configuration instructions, tur n to page 16.
• For Windows 2000configuration instructions, tur n to page 24.
• For Windows NTconfiguration instructions, tur n to page 28.
• For Novell Client & Serverconfiguration instructions, turn to page 38.
If you are using an operating system other than
Windows 98,Windows 95, or Windows NT,you
will find the network driver installation instruc-
tions on the Driver Disk’s readme.exefile.
6
NNoottee:: If you intend to use
both 10Mbps and
100Mbps components on
your network, you will
need an autosensing hub
or switch. For more infor-
mation on autosensing
hubs or switches, go to
the Linksys website at
www.linksys.com.
NNoottee:: Some screen shots
in the following sections
will vary depending on
which version of the
LNE100TXcard you are
installing.
LNE100TX v4 test doc.qxd 3/22/00 4:11 PM Page 6