SPECIAL HEAD?

Is used when a special paper path size is installed (2.125”, 2.5”, 2.7”...) Here are the following choices:

NO

NO special head (factory default)

ON P1

SINGLE PATH PRINTER ONLY. DUAL PATH PRINTER PATH #1

ON P2

DUAL PATH PRINTER PATH #2

ON BOTH

DUAL PATH PRINTER BOTH PATHS

REV ADJ2 P1

DUAL & SINGLE PATH PRINTER WITH REV ADJ2 PATH ONLY

REV ADJ2 P2

DUAL PATH PRINTER WITH REV ADJ2 PATH ONLY

REV ADJ BOTH

DUAL PATH PRINTER WITH REV ADJ2 PATH ONLY

PATH TYPE?

Defines the number of paper paths used.

Here are the following choices:

PATH 1

Locks a Dual path printer onto path#1 (all single path printers) (factory default)

PATH 2

Locks a Dual path printer onto path #2

DUAL

Is used for Dual path printer

DUAL SUPPLY

Please consult your programming Guide (Dual Printer Supplement)

VENTEK DUAL

Special settings only used by certain customers.

BUFFER MODE?

Defines when the printer will go busy.

Here are the following choices:

SINGLE MODE 1

Go busy after each print command inserted in buffer

SINGLE MODE 2

Go busy after receiving <p> command

MULTIPLE MODE

Go busy when the input buffer is full (~4k) (factory default)

CLEAR DOWNLOAD?

Clears those items downloaded by the operator (PCX or softfonts).

Your choices are YES or NO.

DEFAULT SETTING

Resets the printer back to the factory default setting.

Your choices are YES or NO.

INC CUT1 COUNT?

Enables the operator to move the cut or tear position to the left (towards the ticket entrance area). Cut counts are increments of .003” for 300dpi and .002” for 200dpi. The count value is changed by depressing CHOICES.

16 is factory default.

DEC CUT1 COUNT?

Enables the operator to move the cut or tear position to the right (towards the ticket exit area). Cut counts are decrements of .003” for 300dpi and .002” for 200dpi. The count value is changed by depressing CHOICES. 16 is factory default.

12

Page 18
Image 18
Boca Research FSP 46, FSP 42 Special HEAD?, Path TYPE?, Buffer MODE?, Clear DOWNLOAD?, Default Setting, INC CUT1 COUNT?