Body Solid 1.3 manual Handlebar Support Post Assembly

Handlebar Support Post Assembly

Note: During the handlebar assembly process it is best to wait to tighten all screws until after the handlebars are assembled.

1.(a.) Locate the right side handlebar support post, remove the three Button-Head screws at the bottom of the post, and lay the post on the treadmill deck with the bottom of the post next to the top of the post coming up from the base. Push together each of the two connectors on the bottom of the support post. (see illustration a).

(b.) Push the handlebar support post into the base frame. Be careful not to pinch the wiring when you slide the top support post into the base tube.

Make sure that you align the 3 holes on the bottom of the tube with the 3 holes in the base tube (see illustration b).

a b

Align the

holes on the

outside of the frame

2.Take the left side oval support post and slide it into the oval tube on the left side of the base. Make sure that you align the 3 holes on the bottom of the tube with the 3 holes in the base tube (see illustration b).

Note: The left oval support post does "not" have wire connectors coming out of the bottom.

8