ASSEMBLY INSTRUCTIONS
NOTE: Before setting up your cultivator / edger, disconnect the spark plug wire from the spark plug.
POSITIONING THE HANDLEBARS
1.Loosen the two knobs on the inside of the handlebars (Fig. 1).
2.With the unit upright, swing the handlebars up into the operating position (Fig. 2).
NOTE: Take care not to pinch the throttle cable or switch wires when positioning the handlebar.
3. Tighten the knobs to secure the handlebars in place.
NOTE: Do not
4. Reconnect the spark plug wire to the spark plug.
Handlebars
Bolt
Handlebar
Knob
Washer | Hole |
| |
| Fig. 1 |
Fig. 2
ADJUSTING TINE DEPTH
To adjust the wheel support bracket proceed as follows:
1.Stop engine and disconnect spark plug to avoid accidental starting.
2.Remove cotter pin from the clevis pin and slide clevis pin out of tailpiece bracket (Fig. 3).
3.Slide the wheel support bracket up or down in the tailpiece, aligning the holes to the desire height.
4.Place the clevis pin through the hole and secure with cotter pin.
Clevis Pin
Cotter Pin
Wheel
Support
Bracket
Tailpiece Bracket
Fig. 3
ATTACHING THE EDGER WHEEL AND BLADE
To convert the cultivator to an edger proceed as follows:
1.Push the On/Off switch to Off (O) position to stop engine and tines and disconnect spark plug to avoid accidental starting.
NOTE: It may be necessary to lay the cultivator / edger back in a horizontal position on a flat level surface with the upper handle touching the ground.
2.Remove the click pin from each end of the tine shaft and slide the tines off the shaft.
3.Slide the edger wheel, with the hub facing inward, onto the right side of the tine shaft and secure with the click pin in the inside hole (Fig. 4).
4.Slide the edger blade with the hub facing out onto the left side of tine shaft and secure with the click pin in the inside hole (Fig. 4).
5.The edger guide line indicates where cutting will occur. Guide the unit along a flowerbed, sidewalk, or driveway so the edger guide line is above the desired line of cut.
Edger Guide
Line
Hub
Edger Wheel
Click Pin
Tine Shaft
Edger Blade
Fig. 4
7