ATTACHING THE CHIPPER CHUTE (Model 465A 8 H.P. chipper shredder only)
Chipper
Chute
Weld Stud (A)
Weld Stud (A)
Hex Bolt
Flat Washer
Hex Nut
Frame
ALL MODELS
1.To attach the bag, place the opening of the bag over the chute deflector so it completely covers the chute deflector. See Figure 5
2.Depress the plunger on the drawstring, and pull on the drawstring until the bag is tight around the chute opening. Release plunger to lock it into position. See Figure 5
Brace
Weld Stud (A)
Figure 4
1.Remove the three cupped washers and hex nuts from the weld studs beside (A) the opening on the left side of the housing. See Figure 4
2.Remove the two hex bolts, lock nuts, and flat washers from the two holes on the upper end of the brace.
3.Place the chipper chute over the weld studs so the slot on the chute is towards the bottom. Align the three holes on the chute with the three weld studs.
4.Replace the three cupped washers (cupped side against the chipper chute) and hex nuts that you removed in step 1. Do not tighten the nuts at this time. Make sure to place the cupped side of the washer against the chipper chute.
5.Your unit is shipped with one end of the brace already secured to the lower frame. Loosen the bolts securing the brace to the frame.
6.Align the holes on the chute with the holes on the brace.
7.Attach brace to chipper chute with the hardware removed earlier from the brace. See the illustration above for proper order. Tighten.
8.Tighten the bolts securing the brace to the frame.
9.Tighten the three nuts on the weld studs holding the chipper chute to the flail housing.
Figure 5
3.Fill engine with oil as instructed in separate engine manual included with your unit.
7
