11.When reassembling the blade, tighten center bolt to between 550 and 650
1.Insert screw driver through hole
2. Blade should be parallel to ground
Screw
DriverBlade
Ground
Figure 10
SECTION 10: OFF-SEASON STORAGE
Prepare your
1.Clean and lubricate the shredder thoroughly.
2.Refer to engine manual for correct engine storage instructions.
3.If storing an unventilated or metal storage shed, coat metal parts with a light oil or silicone to prevent rust.
4.Store in a cool dry place. Do not store next to corrosive materials such as fertilizer.
SECTION 11: TROUBLE SHOOTING GUIDE
Trouble | Possible Cause(s) | Corrective Action |
|
|
|
Engine fails to start | Dirty air cleaner. | Refer to the engine manual packed with your unit. |
| Choke not in ON position. | Move switch to ON position. |
| Spark plug wire disconnected. | Connect wire to spark plug. |
| Cannot pull recoil cord. | Obstruction lodged in impeller. Stop immediately and |
|
| disconnect spark plug wire. Remove lodged object. |
| Fuel tank empty, or stale fuel. | Fill tank with clean, fresh gasoline. Fuel will not last |
|
| over thirty days unless a fuel stabilizer is used. |
| Fuel | Open fuel |
| equipped). |
|
| Faulty spark plug. | Clean, adjust gap or replace. |
Loss of power; operation | Spark plug wire loose. | Connect and tighten spark plug wire. |
erratic | Unit running on CHOKE. | Move choke lever to OFF position. |
| Blocked fuel line or stale fuel. | Clean fuel line; fill tank with clean, fresh gasoline. Fuel |
|
| will not last over thirty days unless a fuel stabilizer is |
|
| used. |
| Water or dirt in fuel system. | Disconnect fuel line at carburetor to drain fuel tank. |
|
| Refill with fresh fuel. |
| Carburetor out of adjustment. | Refer to the engine manual packed with your unit. |
| Dirty air cleaner. | Refer to the engine manual packed with your unit. |
Engine overheats | Carburetor not adjusted properly. | Refer to the engine manual packed with your unit. |
| Dirty air cleaner. | Refer to the engine manual packed with your unit. |
| Engine oil level low. | Fill crankcase with proper oil. |
Too much vibration | Loose parts or damaged | Stop engine immediately and disconnect spark plug |
| impeller. | wire. Have unit serviced by an authorized service |
|
| dealer. |
Unit does not discharge | Discharge chute clogged. | Stop engine immediately and disconnect spark plug |
|
| wire. Clean flail screen and inside of housing. See |
|
| Maintenance section of this manual. |
| Low engine RPM. | Always run engine at full throttle |
| Foreign object lodged in | Stop engine immediately and disconnect spark plug |
| impeller. | wire. Remove lodged object. |
Rate of discharge slows | Low engine RPM. | Always run engine at full throttle |
considerably or composition | Shredding blade and/or chipper | Replace shredding and chipper blades or see your |
of discharged material | blades dull. | authorized service dealer. |
changes |
|
|
Note: For repairs beyond the minor adjustments above, contact your local authorized service dealer.
12