10.Move choke lever to OFF position as engine warms up.
NOTE : A noise will be heard when finding the start of the compression cycle. This noise is caused by the flails and fingers which are part of the shredding mechanism falling into place, and should be expected. In addition, the flails and fingers will be noisy after the engine is started, until the impeller reaches full speed.
USING YOUR CHIPPER-SHREDDER
WARNING: Do not attempt to shred or chip any material other than vegetation found in a normal yard (i.e., branches, leaves, twigs, etc.).
IMPORTANT: There is a flail screen located inside the housing in the discharge area. If the flail screen becomes clogged, remove and clean as instructed in the Maintenance section.
WARNING: The | |
discharges materials | with considerable |
velocity. Keep away from the area around the discharge chute. Always stop the engine and disconnect spark plug wire when removing or attaching the bag, changing containers, or removing the shredded material. Wear safety glasses and gloves whenever using your chipper- shredder.
•Leaves and small branches up to 1/2" diameter (maximum) can be fed into the hopper assembly when it is in the raised or lowered position.
•For model 462B (5 H.P.), bulky material, such as stalks or heavy branches, up to 2” in diameter should be fed into the chipper chute.
•For model 465A (8 H.P.), bulky material, such as stalks or heavy branches, up to 3” in diameter should be fed into the chipper chute.
WARNING: Do not put material larger
than is specified into the hopper, and/or into the chipper chute. Personal injury or damage to the machine could result.
•If it becomes necessary to push material into the
LOWERING THE HOPPER ASSEMBLY
1.To lower the hopper assembly, use one hand to grasp the
2.Pull out on the release knob, and lower the hopper assembly to the ground.
NOTE: For best performance, it is important to keep the shredding blade and the chipper blades sharp. If the composition of the material being discharged changes (becomes stringy, etc.) or if the rate at which the material is discharged slows down considerably, it is likely that the shredding blade and/ or chipper blades are dull and need to be sharpened or replaced. Refer to Maintenance section.
SECTION 9: MAINTENANCE
GENERAL RECOMMENDATIONS
•Always observe safety rules when performing any maintenance.
•The warranty on this chipper shredder does not cover items that have been subjected to operator abuse or negligence. To receive full value from the warranty, operator must maintain the chipper shredder as instructed in this manual.
•Periodically check all fasteners and make sure these are tight.
WARNING: Always stop the engine and disconnect the spark plug wire before
performing any maintenance or adjustments. Never remove discharge chute till the engine has completely stopped.
WARNING: Temperature of muffler and nearby areas may exceed 150o F(65oC). Avoid these areas.
LUBRICATION
Lubricate the pivot points on the release knob bracket, hopper assembly, chute deflector and once a season using a light oil.
CLEANING
•Clean engine periodically. Remove dirt and debris with a cloth or brush.
•Frequently remove leaves, dirt and debris from cooling fins, air intake screen and levers and linkage. This will help ensure adequate cooling and correct engine speed.
9
