INTEGRUS Installation and User Instructions Connecting to an Integrus transmitter | en 8 |
|
|
3Connecting to an Integrus
transmitter | Note: To connect the floor signal, a cable | |
with a male XLR connector and a male | ||
| ||
3.1 Connecting interpreters desks | cinch connector must be made. See | |
figure 3.1 and figure 3.2 for the wiring. | ||
LBB 3222/04 directly | ||
|
An Integrus transmitter requires the LBB 3422/20 |
|
Integrus audio input and interpreters module to direct- |
|
ly interface with one or more LBB 3222/04 |
|
interpreter desks. This module must be mounted in |
|
the transmitter housing (see the Integrus installation |
|
manual). |
|
Up to 12 interpreter desks can be |
|
nected to the module. The system cable of the first |
|
interpreter desk is connected to the |
|
connector on the Integrus audio input and interpreters |
|
module. The system cables of the next desks are loop- |
|
through connected to the system input plugs on the |
|
preceding desks. |
|
The floor signal for the interpreters desk is connected |
|
to the |
|
an XLR connector. The floor signal can come from a |
|
CCS 800 analogue conference system (i.e. the line out- | Figure 3.1 Connecting one or more LBB 3222/04 |
put cinch connector, see the CCS 800 installation man- | interpreter desks directly to the modular |
ual) or from an external audio source, such as an audio | IR transmitter |
mixer. |
|
The DIL switches on the Integrus audio input and interpreters module must be set to ‘Direct connection to LBB 3222/04 interpreter desks’ (see section 2.2). The ‘Aux. Input’ mode of the Integrus transmitter must be set to ‘Emergency/Mono’ (see the Integrus installa- tion manual).
|
| XL | |
Integrus | 1 | CCS800 | |
2 | |||
| |||
3 | Line output | ||
| |||
|
|
Figure 3.2 Wiring of the cinch to XLR connecting cable
Bosch Security Systems