INTEGRUS Installation and User Instructions Integrus audio input and interpreters module | en 7 |
|
|
2.2Configuration
Before using the Integrus audio input and interpreters module, the operation mode must be chosen by setting the DIL function switches on the module’s circuit board:
•Select the mode in which the module must operate:
1.As an interface to one or more LBB 3222/04 interpreters desks.
2.As an interface to other audio sources.
•Select if floor distribution (see section 1.6) should be enabled.
1.Enable floor distribution when LBB 3222/04 interpreters desks are directly connected
2.Disable floor distribution when LBB 3222/04 interpreters desks are connected via a CCS 400 system.
•Select the channels on which the module’s signals will be distributed.
The table below lists all the settings.
Notes:
•If floor distribution is enabled (DIL switch
•When interfacing between more than one LBB 3222/04 interpreter desk and the
(DIL switch
•Do not use a CCS 400 power supply in combination with direct connection to LBB 3222/04 interpreter desks, as this will cause a fuse to blow.
•When the Integrus audio input and interpreters module is used in combination with audio signals connected to the cinch inputs of the Integrus transmitter, the signals on corresponding channels are mixed.
•Check the positions of the
DIL | Switch | Function | On | Off |
|
|
|
|
|
I | 1,2,3,4,5,6,7,8 | Interpretation | Direct connection to | Connection to |
|
|
| LBB 3222/04 interpreters desks | other audio sources |
|
|
|
|
|
II | 1,2,3,4,5,6,7,8 | Interpretation | Direct connection to | Connection to |
|
|
| LBB 3222/04 interpreters desks | other audio sources |
III | 1,2,3 | Interpretation | Direct connection to | Connection to |
|
|
| LBB 3222/04 interpreters desks | other audio sources |
|
|
|
|
|
III | 4 | Floor distribution | Disabled | Enabled |
III | 5 | Channel selection | Channels | Channels |
|
|
|
|
|
III | 6,7,8 | Not used |
|
|
|
|
|
|
|
Bosch Security Systems
