Solution 64 
User Guide
Main Office A001
Disarmed
Press OK or MENU
If the area is turned All On, the keypad will display:
Main Office A001
Armed All On
Area 1 Name
EXIT NOW
When exit time has expired, the keypad will display that all areas are turned All On (Armed).
If the area is turned Part On, the keypad will display:
Main Office A001
Armed Part On
3.To exit, press [OK].
Areas > Commands >
Turn Area On/Off | MENU |
This menu allows you to turn an area All On or off. Enter programming mode (PIN + MENU) then,
1.Enter [MENU] + [2] + [0] + [1].
A list of different areas will display on the keypad.
A001 Reception Area
A002 Sales Dept
A003 Administration Dept
Press , OK or MENU
If an area has already been turned All On or Part On, a ‘tick’ () will be displayed on the right side of the name description (see A002 Sales Dept above).
2.Use the [↑] and [↓] keys to select the area that you want to turn on or off, then press [OK] to select. Alternatively, you can enter the area number you want to turn on or off, then press [OK].
Areas > Commands >
Turn All Areas On | MENU |
This menu allows you to turn on all areas that your PIN has been assigned to at the same time All On. The keypad display below shows the area icons 1 through to 8.
Enter programming mode (PIN + MENU) then,
1.Enter [MENU] + [2] + [0] + [2].
The keypad will display the exit time bar to prompt you to exit all areas. You should leave all areas now.
Area 1 Name
ARMED
Fri,Aug,13 5:34 pm
Area icons will only display if programmed to i do so by your security installer.
Note
Areas > Commands >
Turn All Areas Off | MENU |
This menu allows you to turn off all areas that your PIN has been assigned to at the same time. However, this menu requires at least one area that has a keypad assigned to it to be disarmed before you can access this command.
Enter programming mode (PIN + MENU) then,
1.Enter [MENU] + [2] + [0] + [3].
Areas > Commands >
Move To Area | MENU |
This menu allows you to operate multiple areas from the same keypad when the system has been partitioned. Before operating a different area, you will need to move the keypad to the area that you want to operate.
Enter programming mode (PIN + MENU) then,
1.Enter [MENU] + [2] + [0] + [4].
A list of different areas will display on the keypad.
A001 Reception Area
A002 Sales Dept
A003 Administration Dept
Press , OK or MENU
2.Use the [↑] and [↓] keys to select the area that you want to move the keypad display to, then press [OK] to select. Alternatively, you can enter the area number that you want to move the keypad display to, then press [OK].
14 | Bosch Security Systems |
09/06
BLCC110U
