Step 5 and 6: Install Oven and Test Operation
5. Install Oven
1.Slide oven into cabinet cutout.
2.Push straight in until oven trim is flush with
cabinet wall, being careful not to crimp flexible con- duit between oven and cabinet back wall. The oven should be straight, not crooked.
3. Install screws (two or four depending on model) through tap holes in trim.
4.Test the oven mode.
Turn cooking mode selector knob to BAKE. The following should occur:
•350 °F (the default baking temperature) and COOK appear in the display.
•Red preheat indicator lights up.
•Oven light and fan turn on.
If installing a double oven, test the second oven as well.
6. Test Operation
For 700 Series Models:
1.Verify that all control knobs are in the OFF position.
2.Turn on power at the breaker.
The clock will appear in the display.
3.Check power at junction box using a volt meter.
For 240 V installation, the reading between the red and black wires (line to line) should be 220 to 240 volts.
For 208 V installation, the reading between the red and black wires (line to line) should be 190 to 208 volts.
4.Test the oven mode. Press COOKING MODE. Turn knob to BAKE. Touch START.
PREHEAT appears in display.
When the oven has reached the set temperature (350° F), it beeps and PREHEAT no longer appears.
If installing a double oven, test the second oven as well.
5.If any of the tests do not result as explained above, contact Bosch service:
For 5000 Series Models:
1.Verify that all control knobs are in the OFF position.
2.Turn on power at the breaker.
The oven will beep and the clock will appear in the display. The lock icons in the display will blink on and off and you will hear a series of clicks as the oven performs a system check.
When successfully completed, only the clock time will appear in the display. The clock is preset to 12:00 AM.
3.Check power at junction box using a volt meter.
For 240 V installation, the reading between the red and black wires (line to line) should be 220 to 240 volts.
For 208 V installation, the reading between the red and black wires (line to line) should be 190 to 208 volts.
5.If any of the tests do not result as explained above, contact Bosch service:
Steps Final
English • 5