CC408 Operators Guide 18. Event Memory Recall
EN 15
18. Event Memory Recall
Use this function to replay the last 40 events that occurred to the system. The event memory history replays all alarms and arming/disarming of the system in AWAY Mode, STAY Mode 1, and STAY Mode 2.
The system cannot differentiate between arming the system in STAY Mode 1 or STAY Mode 2.
How to Enter Event Memory
Enter your
19. Day Alarm
Day alarm allows a combination of zones to be monitored during the disarmed state by beeping the codepad buzzer. Only your installer can program zones 1 to 4 to operate for day alarm.
Example
A day alarm can be set up at the front door of a shop with a pressure mat or electronic beam that customers activate as they enter and exit the shop. As the customers walk onto the pressure mat or break the electronic beam, the codepad buzzer beeps.
How to Turn Day Alarm On
Hold down the [4] key until three beeps sound. Day alarm turns on. All zones programmed for day alarm operation cause the codepad buzzer to beep during the disarmed state when activated.
How to Turn Day Alarm Off
Hold down the [4] key until two beeps sound. Day alarm turns off.
20. Remote Arming By Telephone
Use this feature to arm your system from any remote location using a telephone. For security reasons, the system cannot be disarmed using this method. This feature requires a
How to Remotely Arm your System Using the Telephone
1.Call the telephone number connected to your control panel.
2.When the control panel answers the incoming call, a short jingle is heard. To arm the system, press the [*] key on the
If you hear modem tones when the control panel answers the incoming call, the system was programmed for remote programming functions by your installer. Wait for a pause between the tones before pressing the [*] key.
After releasing the [*] key on the
3.Hang up the telephone and the system remains armed.
If your installer programs answering machine bypass, you must call the control panel twice to make a connection with the system. For example, call the telephone number that your control panel is connected to, let the call ring no more than four rings, then hang up the telephone. Wait a minimum of 8 seconds before you call the control panel again.
