Prior to installation |
| Electrical connection |
❑With activated carbon filter if
323
max. 1080 
mind. 813 522
170 | 250 |
|
|
|
|
|
|
| |
|
|
|
| 00 |
|
|
| /9 | |
500 |
| 00 |
| |
0/7 |
|
| ||
| 60 |
|
|
|
The complete installation set can be obtained from specialist outlets.
The corresponding accessory numbers can be found at the end of these operating instructions.
Preparing the wall
❑The wall must be flat and perpendicular.
❑Ensure that the wall is capable of providing a firm hold for mounting screws and plugs.
Weight in kg:
|
|
|
| Exhaust air |
|
| Recirculating air |
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
| 60 cm |
|
| 12,5 | 13,5 |
| ||
|
|
|
|
|
| |||
|
|
|
|
|
|
|
|
|
| 70 cm |
|
| 13,0 |
|
| 14,0 |
|
|
|
|
|
|
|
|
|
|
| 90 cm |
|
| 13,9 |
|
| 14,9 |
|
|
|
|
|
|
|
|
|
|
We reserve the right to construction changes within the context of technical development.
Electrical connection
WARNING: THIS APPLIANCE MUST BE EARTHED
IMPORTANT: Fitting a Different Plug:
The wires in the mains lead are coloured in accordance with the following code:
Green and Yellow | – | Earth |
Blue | – | Neutral |
Brown | – | Live |
If you fit your own plug, the colours of these wires may not correspond with the identifying marks on the plug terminals.
This is what you have to do:
1.Connect the green and yellow (Earth) wire to the terminal in the plug marked ‘E’ or with the symbol ( 
), or coloured green or green and yellow.
2.Connect the blue (Neutral) wire to the terminal in the plug marked ‘N’ or coloured black.
3.Connect the brown (Live) wire to the terminal marked ‘L’, or coloured red.
The extractor hood should only be connected to an earthed socket that has been installed according to relevant regulations.
If possible, site the earthed socket directly behind the chimney panelling.
Electrical data:
Are to be found on the name plate inside the appliance after removal of the filter frame.
Before undertaking any repairs, always disconnect the extractor hood from the electricity supply.
Length of the connecting cable: 1.30 m.
If it is necessary to wire the extractor hood directly into the mains:
The extractor hood should only be connected to the electricity supply by a properly qualified electrician.
A separator must be installed in the household circuit. A suitable separator is a switch that has a contact gap of more than 3 mm and interrupts all poles. Such devices include circuit breakers and contactors.
If the connecting cable for this appliance is damaged, the cable must be replaced by the manufacturer or his customer service or a similarly qualified person in order to prevent serious injury to the user.
This extractor hood corresponds to EC regulations concerning RF interference suppression.
22
