Cleaning and care
Disconnect the extractor hood from the electricity supply by pulling out the mains plug or switching it off at the fuse box.
❑At the same time as you clean the grease filters, clean off any grease from all accessible parts of the housing. This significantly reduces the fire hazard and ensures that the extractor hood performs as effectively as possible.
❑Use a hot detergent solution or a mild window cleaner to clean the canopy of the extractor hood.
❑Do not scrape off any dirt that has dried on but loosen it up with a damp cloth.
❑Do not use abrasive cleaning agents or sponges that could cause scratches.
❑Note: Do not use alcohol (spirit) on plastic parts, otherwise the surface may become matt in appearance.
Caution: Ensure that the kitchen is ade- quately ventilated. Avoid naked flames!
Clean the sliding switch with a soft, damp cloth (mild detergent solution) only. Do not use stainless steel polish on the sliding switch.
Stainless steel surfaces:
❑Use a mild
❑Clean the surface in the same direction as it has been ground and polished.
Do not use any of the following to clean stainless steel surfaces: abrasive sponges, cleaning agents containing sand, soda, acid or chloride!
Aluminium and plastic surfaces:
❑Use a soft,
❑Do not use dry cloths.
❑Use a mild window cleaning agent.
❑Do not use aggressive, acidic or caustic cleaners.
❑Do not use abrasive agents.
Replacing the light bulbs
1.Switch off the extractor hood and pull out the mains plug or switch off the electricity supply at the fuse box.
2.Remove the grease filters (see Filters and Maintenance).
3.Press down the bulb cover and disconnect from the light strip.
4.Replace the bulb (standard filament bulb, max 40 W, E14 bulb holder).
5.Attach the lamp cover again.
6.
7.Plug the appliance into the mains or switch it on at the fuse box.
18
