DS9400 Series Release Notes for Firmware V2.07 Trademarks
Upgrade Information
Trademarks
Gentex™ is a trademark of Gentex Corporation, Fire Protection Group
CleanMe® is a registered trademark of GE Interlogix
1.0 Fixed Items in Firmware Version V2.07
The D9400 Series Fire Alarm Control Panel (FACP)
V2.07 fixes two bugs:
If this firmware is installed in a control panel that has been running version 1.x software, it is necessary to erase the old programming in the control panel and re- select the control panel type when the control panel is first powered up. Be careful to select
3.0 Fixed Items in Firmware Version 2.05
•When the Drill button was pressed, only the Local Notification Appliance Circuits would activate. This has been corrected, and the DS9484 Remote NAC supply also activates.
•In Firmware Version V2.06, a bug was created when silencing a multiple output module (DS9488/B or DS9489/B), causing some outputs not to silence. This worked correctly in other firmware versions, but worked incorrectly when changing the silence priority feature.
2.0 Fixed Items in Firmware Version 2.06
Version 2.06 firmware for the DS9400 Series Fire alarm Control Panels (FACP) incorporates a change to Preassigned Zone 61 and a bug fix for Outputs assigned to Silencable points.
•Preassigned Zone 61 – General Water flow (Silencable) has been changed to a Non- Silencable Zone type.
•Preassigned Zone 53 – General Fire alarm (Silencable) has been fixed so that a Non- Silencable point will take priority over a Silencable point.
1.This condition may happen when both Silencable and
2.Version 2.05 and prior would configure the output to Silencable or
Version 2.05 firmware for the DS9400 Series Fire Alarm Control Panels (FACP) incorporates a bug fix for
•
1.When selecting a device type of I/O, the first address programs correctly but if any device option is selected other than “no device,” the second address results in an “Address Error 2.” This V2.05 ROM fixes this issue.
2.The
4.0 Fixed Items in Firmware Version 2.04
Version 2.04 firmware for the DS9400 Series Fire Alarm Control Panels (FACP) incorporates several new features and improvements:
•Gentex™ Sync Protocol. The control panel can now send Gentex protocol to Gentex Notification Appliance Circuit (NAC) devices. Gentex NAC devices can be added directly to the NAC circuits without a sync module.
•CleanMe®. The control panel recognizes the
2 | Bosch Security Systems 8/06 36925V |