RAID Subsystem
6.3.2 | DIMM Module Replacement Procedure |
i
NOTICE!
If you are going to replace or upgrade a DIMM module, please follow the instructions below. If you do not want to replace or upgrade a DIMM module and would like to install a controller module, please see Section 6.2.3 Replacing the Controller Module.
If a DIMM module fails or if a DIMM module with a higher memory capacity is required, the onboard DIMM module must be replaced. To replace the DIMM module:
1.Remove the controller module. See Section 6.2.3 Replacing the Controller Module.
2.Remove the previously installed DIMM module from the DIMM socket. To do this, push the white module clips on either side of the DIMM module down. By doing this, the previ- ously installed modules will be ejected from the DIMM socket. (See Figure 6.2)
Fig. 6.2 Push Back the Module Clips on the Sides of the DIMM Module
3.Gently pull the DIMM module out of the DIMM socket. (See Figure 6.2)
4.Insert the DIMM module into the DIMM socket. Align the DIMM module with the DIMM socket. Once aligned, gently push the DIMM module into the socket. The white clips on the sides of the socket will close automatically and secure the DIMM module into the socket.
Fig. 6.3 Insert the DIMM Module
5.Reinstall the controller module. After the DIMM module has been properly installed, the controller module must be reinstalled. To do this, align the controller module with the controller module bay. Then gently push the controller module in the controller bay.
Carefully push the controller until you feel the contact when the board edge connectors are mated to the backplane. Do not use force. If unusual contact resistance is felt, try it again. Next secure the controller module into the subsystem by fastening the hand screws on the sides.
Bosch Security Systems | F.01U.027.798 V1 2006.06 |
