Bosch Appliances EX14 instruction manual Camera Adjustments

18 en Camera Connections EX14 Marine Camera

4.Remove the desiccant from the plastic bag.

5.Place the desiccant into the enclosure on the side opposite of the cable connections.

6.Tighten the nut of the gland to 1.3 NM torque setting and ensure it is sealed well.

7.Perform any required adjustments as detailed in

Section 5.1 Camera Adjustments, page 18 and

Section 5.2 LED Array Adjustments, page 19.

8.Close the enclosure and make sure the sealing gasket is in place and the round tab at the top of the window locks into the top inside of the housing.

5.1Camera Adjustments

This section contains instruction for adjusting the Focus and Zoom settings.

1.Loosen and tilt back the camera’s top cover to access the lens for adjustment.

2.Loosen the lens setscrews for focus/zoom adjustments. See Figure 5.1 on Page 18.

–The setscrew for N --- ∞ is used for image focus (item 1, below).

–The setscrew for T--- W is used for telephoto or wide- angle settings. (item 2, below)

N	W
	T

3.Re-tighten the setscrews after focus adjustments have been completed.

F.01U.240.878 1.0 2011.07 Instruction Manual Bosch Security Systems, Inc.