EX14 Marine Camera | Troubleshooting en 39 |
|
|
7Troubleshooting
PROBLEM | POSSIBLE | LIKELY SOLUTION |
| CAUSE |
|
|
|
|
No Video | Power supply | Check input power connections at |
| connections | the cable leads. Check for loose |
|
| wires |
|
|
|
No Video | Power supply - | If connected to DC check input |
| Voltage range | voltage range of |
|
| connected to AC , check input |
|
| voltage range of |
|
| the voltage and current at the Input |
|
| power cable. The current should be |
|
| >.02 A and <1.0 A. |
|
|
|
No video | Video | Determine if wiring polarity at |
| connections | Video Connector terminal block is |
|
| correct. Check the cable and BNC |
|
| connector. If still no video, connect |
|
| the camera directly to the monitor. |
|
| Check the video signal . If okay, the |
|
| problem is with the |
|
| interconnections. If still no video, |
|
| contact your Bosch service center. |
|
|
|
Poor picture - | Poor video signal | Ensure the video cable is correctly |
Snowy image |
| matched and terminated with |
|
| 75 ohms at each end. Make sure |
|
| the video cables are similar types. |
|
|
|
Snowy Image | Noisy power | Check connections. Relocate or |
| supply | replace the power supply. |
|
|
|
Horizontal scan | Ground looping | Check the coax cable shield is not |
lines, rolling up or | on video cable | touching ground, e.g.a t couplings. |
down |
| Check video polarity. |
|
|
|
Negative, | Low voltage | Check voltage at the input power |
scrambled or |
| cable. Must be >12 VDC or |
faded image |
| >12 VAC. |
|
|
|
Bosch Security Systems, Inc. | Instruction Manual | F.01U.240.878 1.0 2011.07 |