Bosch Appliances FPE-1000-NE, FPE-1000-NF, FPE-1000-NW 1Safety

6en | Safety Networking Cards

F.01U.214.374 | 01 | 2012.08 Installation Manual Bosch Security System, Inc.

1Safety

Use these instructions to install FPE-1000 Networking Cards in FPA-1000 Analog Addressable

Fire Panels.

1. Install, test, and maintain the networking cards and the FPA-1000 panels according to

these instructions, NFPA 72, local codes, and the Authority Having Jurisdiction (AHJ).

2. Follow the procedures in this document to avoid personal injury and damage to the

equipment. Failure to follow these procedures can cause improper operation of the fire

panel and/or network. Bosch is not responsible for improperly installed, tested, or

maintained devices.

3. Failure to follow the mounting instructions in this document can damage the fire panel.

For detailed wiring style requirements and complete programming instructions, see the

FPA-1000 Installation and Operation Guide.

NO WARRANTY

BECAUSE THE PROGRAM IS LICENSED FREE OF CHARGE, THERE IS NO WARRANTY FOR THE

PROGRAM, TO THE EXTENT PERMITTED BY APPLICABLE LAW. EXCEPT WHEN OTHERWISE

STATED IN WRITING THE COPYRIGHT HOLDERS AND/OR OTHER PARTIES PROVIDE THE

PROGRAM "AS IS" WITHOUT WARRANTY OF ANY KIND, EITHER EXPRESSED OR IMPLIED,

INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND

FITNESS FOR A PARTICULAR PURPOSE. THE ENTIRE RISK AS TO THE QUALITY AND

PERFORMANCE OF THE PROGRAM IS WITH YOU. SHOULD THE PROGRAM PROVE

DEFECTIVE, YOU ASSUME THE COST OF ALL NECESSARY SERVICING, REPAIR OR

CORRECTION.

IN NO EVENT UNLESS REQUIRED BY APPLICABLE LAW OR AGREED TO IN WRITING WILL ANY

PROGRAM AS PERMITTED ABOVE, BE LIABLE TO YOU FOR DAMAGES, INCLUDING ANY

GENERAL, SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES ARISING OUT OF THE USE

OR INABILITY TO USE THE PROGRAM (INCLUDING BUT NOT LIMITED TO LOSS OF DATA OR

DATA BEING RENDERED INACCURATE OR LOSSES SUSTAINED BY YOU OR THIRD PARTIES

DANGER!

Fire panels are Life safety devices. Only trained personnel should install and program these

panels!

Any panel in a network can control all other panels in the network (e.g. silencing an alarm or

resetting the system). Access to panels should be restricted to properly trained personnel.

NOTICE!

Bosch Security Systems, Inc. has tested and approved the FPA-1000 Analog Addressable Fire

Panels and associated Netwotrking Cards including the system and card software. The system

must only be operated with the software included in the product delivery or with authorized

software upgrades (downloadable from the official Bosch homepage). Bosch cannot be held

responsible if devices are operated with any modified software or software from other

sources.