Bosch Appliances GVS1000 manual Camera Control Power Indicator, 6Termination Jumpers

34 en Test SoftwareGlobal View Station 1000

6.5.1	Reset Button
	–	SW1 – resets the board to default settings
	–	Resetting should be used when changing the system address or communication protocol
		when the unit is powered.

6.5.2	System Communication
	– T1 – Connects to system input
	– to receive system communication from controller
	– required for both simplex (2-wire configuration) and duplex (4-wire configuration)
	– T2 – connects to system output
	– to send system communication to controller – OPTIONAL
	– required only for duplex (4-wire configuration)
	– LED5 – indicates communication traffic to the system (LED always on when diagnostics
	function engaged).

6.5.3	Camera Control Power Indicator
	– LED6 – indicates presence of power
	– LED6 ON = camera control board power on
	– LED6 OFF = camera control board power off
	– Default: LED6 on (when system powered)
	– CN4 – connects to 12VDC for power input

6.5.4	Address Selection
	– DIP1 – Switches 1-4
	– Switches in various combinations of on/off will allow address setting of 1-16.
	– Default address: 1
	– Address MUST be the same for Auxiliary Control board (in PSU), Camera Control board
	(in camera assembly), and Code Translator (in PSU).
	– Refer to the GSV1000 Installation Manual.

6.5.5	Protocol Selection
	– DIP1 – Switch 5
	– Switch ON: Pelco D mode
	– Switch OFF: Pelco P mode
	– Default: Pelco D mode (switch off)
	– Switch UP position is ON

6.5.6Termination Jumpers

– For Biphase models, ensure Pelco D mode is enabled.

– JP3 / JP4 – controls the impedance of communication lines

– JP3 – T1 telemetry jumper

– JP4 – T2 telemetry jumper – ALWAYS CLOSED

– JP5 – diagnostics tool jumper – ALWAYS OPEN

F.01U.173.867 2.0 2010.11 Operations Manual Bosch Security Systems, Inc.