LE10 Radio Receiver | Operation en 21 |
|
|
6.7.2Reset of a battery-low indication with button T1
Device behavior
–The green LED stays permanently on.
–The red LED is already blinking every 10 seconds.
Upon pressing button T1 min. 1 second, there is a reset of the
–The red LED turns off.
–Relay 2 switches off.
NOTICE!
If you disconnect and reconnect the power supply, the battery- low indication will be reset as well.
6.8Extended MIYN46 (mode 8, only with SW 1.10)
Programming and deleting of transmitters is done as in Mode 1.
Standby
–The green LED stays permanently on.
–The red LED is off.
–Relay 1 is switched off.
–Relay 2 is switched off.
When a MIYS37 transmitter, MIYS35 transmitter, MIYRAC contact, MIYMD ManDown Sensor are activated:
–The green LED stays permanently on.
–The red LED turns on for 2 seconds.
–Relay 1 is switched on for 2 seconds.
–Relay 2 is switched off.
When a MIYN46 transmitter’s red or blue button is pressed, or when one of its inputs is activated:
–The green LED stays permanently on.
–The red LED and Relay 1 switch on for 6 minutes or until the green button of the MIYN46 transmitter is pressed.
–Relay 2 is switched off.
Bosch Security Systems | User Manual | F.01U.278.517 V2.0 2012.11 |
