LE10 Radio Receiver | Installation en | 9 |
|
|
|
3Installation
3.1Unpacking
The LE10 Radio Receiver is carefully packed for transportation. The components contained in the box are protected, but should be handled with care. Store the packaging material for further use (storage or transport). In case of defective or missing equipment, do not try to install the LE10 Radio Receiver. Contact immediately your local representative.
1.Take all components out of the box and place the LE10 Radio Receiver on the working space.
2.Check that the following accessories are delivered: the fixings (2 screws and 2 screw anchors) and this user manual.
3.Check that the LE10 Radio Receiver and its accessories have not been damaged during transportation.
3.2Connecting the power supply
There are two different ways to connect the power supply of the LE10 Radio Receiver. After connection, the LE10 Radio Receiver will be in standby mode.
3.2.1Power supply with the RJ12 power socket
The LE10 Radio Receiver can be powered by a power supply unit (PSU). The PSU should be plugged in the RJ12 socket on the rear side of the unit and should be easily accessible at any time. See Section 4.1 Connecting ports, page 11 for access to the socket. See Section 7 Technical data, page 23 for information about the power supply.
3.2.2Power supply connected to a wired installation
The LE10 Radio Receiver can be powered by connecting a wired input into poles 1 and 2 of the connection board. See Section 4.1 Connecting ports, page 11 for information about the power supply.
Bosch Security Systems | User Manual | F.01U.278.517 V2.0 2012.11 |
