LE10 Radio Receiver | Programming en 13 |
|
|
5Programming
5.1Enter programming mode
To enter programming mode, press simply button T1 for the desired time. See Section 4.1 Connecting ports, page 11.
NOTICE!
Both relays will not be activated in the programming mode.
5.2Program a transmitter in modes 1, 2 or 5
NOTICE!
Per programming sequence only one transmitter can be matched. You can program up to 20 transmitters.
To start programming
–Press button T1 for min. 1 second and max. 3 seconds.
Device behavior
–The green LED stays permanently on.
–The red LED blinks slowly for maximum 30 seconds. Within these 30 seconds, activate the transmitter that you want to match, the following behavior should be observed:
–The green LED and the red LED blink alternating for 6
seconds.
This indication confirms that the transmitter is programmed.
–If the transmitter is already programmed, then the red LED blinks fast for 6 seconds after activating the transmitter.
–If 20 transmitters are already programmed, then the red LED blinks fast for 10 seconds directly after activating the button T1 between 1 and 3 seconds.
You can repeat the sequence with another transmitter.
Bosch Security Systems | User Manual | F.01U.278.517 V2.0 2012.11 |
