DinionXF Installation Manual
EN 24
Install I/O --> Alarm submenu
Function | Selection | Description |
ACTIVE | NONE, HIGH, | Selects active_HIGH or active_LOW for the alarm |
| LOW | input connector. Select NONE to disable alarm |
|
| switching. |
|
|
|
ACTION | NONE, MONO, | Selects the operating mode of the camera upon |
| MODE1, MODE2, | switching the alarm input. |
| MODE3 |
|
ALARM | VMD, REMOTE, | • Select VMD to close the output relay upon VMD |
OUT | DAY/NIGHT, | alarms. |
| FILTER MOVE | • Select REMOTE to make the output relay available |
|
| to remote communication devices. |
|
| • Day/night: the alarm output relay closes if the |
|
| camera operates in monochrome mode. |
|
| • Filter move: the alarm output relay closes before the |
|
| filter starts moving (in either direction) and opens |
|
| when the video level has stabilized (2 - 3 seconds). |
|
|
|
EXIT |
| Return to the I/O menu |
|
|
|
Install sync submenu
Function | Selection | Description |
SYNC | INTERNAL, LINE | Select INTERNAL for free running camera operation, |
| LOCK, HV | select LINE LOCK to lock to the power supply |
| LOCK, | frequency, select HV LOCK to lock to the signal |
| GENLOCK | supplied to the external sync input, select |
|
| GENLOCK to lock the subcarrier as well. |
|
|
|
DETECTED |
| Shows the actual sync mode used by the camera. |
SYNC |
|
|
VPHASE | 0, 2, … 358 | Adjusts the vertical phase offset (when in LINE |
|
| LOCK mode and a valid power supply frequency is |
|
| detected). |
|
|
|
HPHASE | Adjust the horizontal phase offset (when in EXT lock | |
| +125 | mode and a valid input signal is detected) |
SUB | 0, 2, … 358 | Adjusts the |
PHASE |
| LOCK mode and a valid |
|
|
|
EXIT |
| Return to the INSTALL menu |
|
|
|
Note
VPHASE, HPHASE and
Bosch Security Systems