Bosch Appliances LTC 4600 instruction manual 4INSTALLATION, 4.1Installing Rack-mountModules, En

LTC 4600 Series Instruction Manual Installation EN 8

4INSTALLATION

4.1Installing Rack-mount Modules

1.Install the LTC 4637 Series card cage unit as described in a later section of this document.

2.Install the fiber optic plug-in module into any available slot of the LTC 4637 Series rack-mount card cage. Certain modules, such as the LTC 4744 and LTC 4745 units are double width, so they require two (2) available rack-mount slots.

•Push the module in completely, so that the 3-pin connector on the rear of the card engages the 3-pin connector on the back plane.

•Each fiber optic plug-in module is equipped with a power LED indicator that illuminates when power is applied to the rack unit.

3.Fasten the module into place by tightening the front panel captive screws into the appropriate mating holes with a small flat blade screwdriver.

4.Connect the applicable video and/or data connections to the appropriate connectors, located either on the front or rear of the module. Refer to the example diagrams later in the individual sections.

4.2Installing Stand-alone Modules

1.Choose an appropriate flat surface where the stand-alone module can be conveniently mounted, then mark the locations of the keyhole slots on the mounting flanges.

•The LTC 4641 Series Video Transmitter is small enough to be installed inside a camera housing. If applicable, mount the module in a convenient location where it will not obstruct access to other items in the housing.

2.Install the appropriate mounting screws (not supplied) into the keyhole locations. Allow sufficient leeway under the screw head for the module to be mounted.

•For the LTC 4641 Series Video Transmitter, a single mounting hole is provided to secure the module.

3.For modules other than the LTC 4641 Series, position the module over screw heads, slide to one side, and then tighten screws.

4.Connect the cable from the supplied power supply to the power input terminals on the module.

5.Connect the supplied power supply to an appropriate power source.

6.Connect the applicable video and/or data connections to the appropriate connectors on the module. Refer to example diagrams for exact details.

Bosch Security Systems July 08, 2008