Bosch Appliances LTC 5136 Setting Fast Address, Feature, AutoDome Camera or

LTC 5136 Series Instruction Manual Setting Fast Address						EN 10
4.5	AutoDome Camera or		•	ON-998-ENTER causes all cameras,
	Receiver/Driver Site Configuration			regardless of Fast address status,		to enter the
				addressing mode.
Follow	the standard installation instructions provided
with the AutoDome Camera or Allegiant Series
Receiver/Driver unit to connect the data cable		to the
unit. Set the address of the AutoDome camera		or
receiver/driver, to the camera number that will		be
selected on the Controller keypad. AutoDome cameras
also support address setting via the on-screen menu
Fast Address feature. The next section outlines setting of
the AutoDome’s Fast Address.
Video	signals from the camera site are NOT connected
to the Controller. The video signal(s) from the camera
site(s) should be connected to an appropriate viewing			Figure FA1
monitor or other video processing equipment (switcher,
multiplexer, etc.).			3. Press ON-26-ENTER. The screen			shown in
5	SETTING FAST ADDRESS		FIGURE FA2 will		be displayed. At this point,
			any	camera whose	ID does not begin with 26
	FEATURE		will	exit the Fast Addressing mode.

Use the AutoDome’s Fast Address feature to set the AutoDome address via the controller and on-screen menus instead of using the switch address (thumbwheel). Fast Address can also be used to change addresses, even if the thumbwheel switch is set.

The following is an example of how to Fast Address an AutoDome (ID number 26636, logical camera #3). The AutoDome being Fast Addressed has the switch address (thumbwheel) set to 0.

1.Call up the camera to the screen you are viewing (i.e. CAM ERA-3-ENTER).

2.Press ON-999-ENTER. The screen shown in FIGURE FA1 is displayed.

•Any camera without a Fast Address will display the screen in FIGURE FA1 when the ON-999-ENTER is used. Make sure you are viewing the camera that you want to program.

•If the camera’s Fast Address is the same as the keyboard address, ON-999-ENTER will make the camera enter the Fast Address mode. This is required to change or disable a

Fast Address.

Figure FA2

4.Press ON-636-ENTER. The screen shown in FIGURE FA3 is displayed. At this point, Camera ID 26636 will be the only camera in the Fast Addressing mode.

Figure FA3

Bosch Security Systems 08May 2013