a. | b. |
|
|
Figure 12.
Wash the blade/base assembly under running water. Do not place the blade/ base assembly in the dishwasher or allow it to stand in water. This will tend to wash out the lubricant. After cleaning, rinse thoroughly and dry before using.
2.To assemble or reassemble blade/base assembly into the blender, insert the blade/base assembly into the blender jar as shown in figure 12b, press down on the quick release handle of the blade/base assembly and turn clockwise to the stop. The blade/base assembly is then back in place.
3.If you have not already done so, remove the motor drive cover and place the blender on the mono drive and turn counterclockwise to lock the blender in place.
a. |
| b. |
|
|
|
Figure 13.
Placing Blender into Operation
Make sure that the switch is in the off position, “O/Off.” Unwind the electrical cord to the necessary length and plug into wall outlet. The blender is now ready for operation.
Normally when blending, the blender jar should be filled with the entire amount of material to be blended, if possible, before switching the appliance on. The cover and cover closure should always be in place after filling the blender jar and before switching the power unit to On. Any subsequent additions to the blended material should be made through the cover opening, see figure
14.For solids and/or granular material, remove the cover closure/funnel to add the material, as shown in figure 14a. For liquids, the closure/funnel may be left in place and the liquids added by pouring it into the closure/funnel, see figure 14b.
Figure 14.
Example of Use of Blender
To familiarize you with the operation of the blender, a sample recipe for mayonnaise is provided below:
Mayonnaise Recipe 1 whole egg
1/3 cup of vegetable oil
2 tablespoons lemon juice or light vinegar
1 teaspoon sugar
1/2 teaspoon dry mustard 1/2 teaspoon of salt
2/3 cup of vegetable oil
Mix all ingredients, except final 2/3’s cup of oil, for a few seconds at speed 1, then quickly pour the oil in through the opening in the cover in a uniformly thick stream, as shown in figure 14b. Operate the blender at speeds 1 or 4 until mixture is thick and smooth (approximately
16
