Acer 6460, 6410 manual Power System Check, Lcd

Error Message	FRU/Action in Sequence
Invalid System Configuration	BIOS ROM
Data	System board
I/O device IRQ conflict	Run Load Default Settings in BIOS Setup Utility.
	RTC battery
	System board
Operating system not found	Enter Setup and see if fixed disk and drive A: are properly
	identified.
	Diskette drive
	Hard disk drive
	System board
No beep, power-on indicator	Power source (battery pack and power adapter). See
turns off and LCD is blank.	Power System Check.
	Ensure every connector is connected correctly.
	Reconnect the DIMM.
	LED board
	System board
No beep, power-on indicator	Power source (battery pack and power adapter). See
turns on and LCD is blank.	Power System Check.
	Reconnect the LCD connector.
	Hard disk drive
	LCD inverter ID
	LCD cable
	LCD Inverter
	LCD
	System board
No beep, power-on indicator	Reconnect the LCD connectors.
turns on and LCD is blank. But	LCD inverter ID
you can see POST on an	LCD cable
external CRT.	LCD inverter
	LCD
	System board
No beep, power-on indicator	Ensure every connector is connected tightly and correctly.
turns on and a blinking cursor	System board
shown on LCD during POST.
No beep during POST but	Speaker
system runs correctly.	System board

Chapter 4 81