Bosch Appliances NDN-265-PIO installation manual Power connection, DC power connection

IP Camera 200 Series Installation en 15

3.4Power connection

The camera can accept power from both the DC12V power input and the Ethernet input at the same time. You can remove either one of the power sources without interrupting camera operation.

3.4.1DC power connection

5 mm

(0.2 in)

22AWG

12 VDC

Figure 3.2 DC power connection

Connect power from a 12 VDC class 2 power supply as follows:

1.Use AWG22 wire; cut back 5 mm (0.2 in) of insulation.

2.Remove the 2-pole connector from the camera cable tree.

3.Loosen the screws and insert the wires.

4.Tighten the screws and reconnect the 2-pole connector to the power connector of the camera cable tree.

Bosch Security Systems Installation Manual AM18-Q0616 v1 2012.02