EÖ | display and numbers | If anE Ö | and a series | of | numbers appear | in | the display panel, there is a f | ||||||||
|
| electronic | system. | Turn | the | appliance off | and | back | on at | the | fuse or circu | ||||
|
| Call customer service | if the same display appears | again. |
|
|
|
| |||||||
F | display and numbers | If anF and a number | flash | in alternation | on | the | displays, | your | appliance ha | ||||||
|
| detected a fault. Refer to the following table | for | possible | remedies. | ||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
Visual indication |
| Fault |
|
|
| Measure |
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
| |||||||
F0 |
|
| An internal error | was Disconnect | the | appliance from the | power | ||||||||
|
|
| produced | while | the | source. Wait a | few | seconds | before | connecting | |||||
|
|
| cooktop | was | working.again. |
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
| If the symbol appears again, call customer | ||||||||
|
|
|
|
|
|
| service. |
|
|
|
|
|
|
|
|
F2
F4
F8
o1
o2/o3
U400
The element is too hotRemove the pans from the elementsF2 .
and has turned off. disappears when you acknowledge the display (by pressing a touch key) and the element ha cooled sufficiently. Wait a few minutes until th elements have cooled down slightlyF2. If appears again after the element is turned bac on, the cooktop is still too hot. Turn off the elements and allow them to cool further.
The pot or pan is tooVerify that the pot or pan is properly position close to the control on the element. Verify that nothing hot is on
panel.touch key panel. Remove the hot item from t control area. Wait a few minutes for the touc key panel to coolF4. Ifappears again after the element is turned back on, call customer serv
The | element | has | beenThe | automatic | shut off | was activated. | |||||||||
in constant operation Turn the | element | off. |
|
|
| ||||||||||
for | too long. |
|
|
| You | can | turn | it | back | on | again immediately. | ||||
|
|
|
|
|
|
|
|
|
|
|
| ||||
The | power | voltage | is Turn | off | the | cooktop. | Wait | a few seconds be | |||||||
too | low. |
|
|
|
| turning | it | back | on. |
|
|
| |||
|
|
|
|
|
| If the indication continues, contact your | |||||||||
|
|
|
|
|
| electricity | supplier. |
|
|
|
| ||||
|
|
|
|
|
|
|
| ||||||||
The | element | has |
|
| It has | been automatically deactivated to protec | |||||||||
overheated. |
|
|
|
| your | cooktop. |
|
|
|
|
| ||||
|
|
|
|
|
| Wait | a | few | minutes for it | to cool down and | |||||
|
|
|
|
|
| it back | on | again. |
|
|
| ||||
|
|
|
|
|
|
| |||||||||
The | cooktop | is |
|
| Disconnect the appliance from the power sour | ||||||||||
connected | incorrectly. at the | circuit breaker or fuse. Check the | |||||||||||||
|
|
|
|
|
| connection and | connect it | again correctly. | |||||||
|
|
|
|
|
| If U400 | appears | again, | call | customer service. | |||||
Notes
The heat is switched on and off to | regulate the temperature of the elemen | ||||
means that the | red | glow below the | element | is not always visible. When | yo |
low heat setting, | the | element turns | off more | frequently, while at a higher | s |
only turns off occasionally. Even | at | the | highest | level, | the element turns | off | |||||
As | the element | is | heating | up, there | may be a | light | buzzing. |
| |||
The | brightness | of | the glow | may | vary from element to element. Depending | ||||||
line of vision, the red glow may | appear | to extend beyond | the marked | edg | |||||||
element. |
|
|
|
|
|
|
|
|
|
| |
These are technical characteristics | and | have no impact on | quality or | funct | |||||||
20
