Bosch Appliances PCH 615 FAU Operating instructions, Installation, Preparing to install

Installation

Preparing to install	This installation must conform with the following:
	• Manufacturer’s Installation instructions
	• Local Gas Fitting Regulations
	• Municipal Building Codes,
	• AGA Installation Code for Gas Burning Appli-
	ances. (AS 5601/AG 601)
	• S.A.A. Wiring Code
	• Local Electrical Regulations
	• Any other statutory regulations
	These built-in hobs are intended to be inserted in a
	benchtop cutout.
	Only an authorised person should connect the appli-
	ance.
	Installation dimensions are shown in Fig.1

Operating instructions

Burner locations

13
1. Medium burner	3.	Wok burner
2. Medium burner	5.	Small burner

1

Burner ignition & control

Depress control knob and turn anti-clockwise to ‘High flame’ position. Hold the knob down for a few sec- onds until the flame ignites. Keep control knob de- pressed for a few seconds to activate the flame failure device. If ignition fails, depress knob again and wait for ignition. Turn anti-clockwise to set the flame to the desired intensity.

All burners are fitted with a flame failure device which shuts off the gas supply if the flame extinguishes for any reason. To re-ignite, wait 30 seconds for any unburnt gas to disperse before repeating the ignition procedure described above.

To turn off the gas supply to a burner turn the control knob clockwise to the ‘OFF’ position. (Refer Fig. 14)

Before connecting the unit, check whether the local connection conditions (type of gas) are compatible with the unit’s settings. Observe any special condi- tions imposed by local suppliers (utilities). The specifi- cations of this cooktop are stated on the data label located on the bottom of the cooktop base.

14

The control knob is used to adjust the flame of the gas burner.

‘Low flame’ graphic = lowest output ‘High flame’ graphic = highest output

6 11