Minimum flame adjustment
1Turn the control knob to minimum.
2Remove the control knob from the valve spindle. Refer Fig. 8.
3Using a screwdriver carefully pry off the hard plas- tic seal. Refer Fig. 9.
4Using a small screwdriver carefully remove the soft rubber seal. Refer Fig. 10.
5The adjustment screw is positioned at the rear lower section of the valve. Refer Fig. 11 & 12.
6To adjust the minimum flame for N.G. replace the control knob onto the spindle, light the gas and turn the control knob to the small flame position. Screw the adjustment screw
Clearances | A range hood fitted above the top must be installed |
| according to the installation instructions for the range |
| hood. A minimum distance of 650 mm is required for |
| a range hood and 750 mm for an exhaust fan. |
| If the distance measured from the periphery of the |
| nearest burner to any vertical surface is less than 200 |
| mm, the surface shall be protected in accordance with |
| clauses 5.12.1 & 5.12.1.2 of AS 5601/AG 601. |
| Leave a space at least 100mm between any drawer, |
| partition or oven that is installed underneath the |
| cooktop. |
| Minimum thickness of benchtop is 15mm. See Fig. 2. |
2
To adjust the minimum flame position for LP Gas the screw must be fully tightened down clockwise.
7Remove the control knob, replace the seals in re- verse order and refit the control knob.
89
Installation of cooktop into the kitchen bench
Installation procedure:
1. For cutout dimensions and clearances refer Fig 1.
2The hotplate is factory fitted with sealing tape around the lower edge of the hob and two pres- sure clamps front and rear. The seal keeps the en- tire work surface watertight and prevents spillage from leaking into cupboards underneath. Please ensure that the sealing tape is not disturbed during the installation process. Refer Fig. 3.
1011
12
3
3Place hotplate on top of the bench
NOTE: If it is necessary to dismount the hob, press upwards only from underneath.
10 | 7 |