Electrical Connection
ELECTFiICAL CONNECTmON
Electrical Shock Hazard
To avoid ebctricaJ shock, do not work on an energized circuit. Doing so could result in serious injury or death. OnJy quaJified eJectricians shouJd perform ebctrical work. Do not attempt any work on the dishwasher electric suppJy circuit until you are certain the circuit is
Figure 28 | Fire Hazard |
| |
| To avoid a fire hazard, make sure eJectricaJ work |
| is properly installed. Only qualified electricians |
| shouJd perform electricaJ work. |
| Grounding instructions |
| The dishwasher must be properly grounded before |
| operating, This appliance must be connected to a |
| grounded metal permanent wiring system, or an |
| equipment grounding conductor must be run with the |
| circuit conductors and connected to the equipment |
| grounding terminal or lead on the dishwasher, Make sure |
| that the dishwasher is connected to a suitable ground in |
| compliance with all local codes or, in the absence of a |
Casing | local code, with the NATIONAL ELECTRICAL CODE in |
the United States or the CANADIAN ELECTRIC CODE | |
| |
Figure 29 | state or municipal or local codes that apply, |
1Retrieve the strain relief plate, and install a strain relief (not supplied) into the opening on the strain relief plate, NOTE: Orient the strain relief as shown in Figure 28,
2Pass the electrical supply cable through the strain relief, as shown in Figure 29, Make sure the outer wire casing extends about 1/2" (13mm) through the strain relief,
3Tighten the strain relief screws,
4Slide the strain relief plate into the junction box, and secure it to the junction box with the supplied screw,
13
